Troubleshooting - MVP EV18 Instructions Pour L'installation, Emploi Et Entretien

THE DISHWASHER
WORK ?
1- Verify the main water supply inlet
is correctly connected, open and
free from any obstructions.
2- Verify
main electrical
working without any electrical break in
connection.
3- Verify the door is properly closed.
DISHWASHER DOES NOT WASH
WELL ?
1- Verify the filters are clean, if not,
clean them. (see par. 3D4)
2- Verify the washing water jets on the
washing arms are not obstructed by
any solid residue.
3- Verify the correct amount and quality
of detergent and rinse aid. (see par.
3B2/3C2)
4- Verify the dishes are correctly
loaded in the dishwasher. (see par.
3B6/3C7)
5- Washing cycle is too short. Use
another cycle (if available) or repeat
the washing cycle.
THE DISHES ARE NOT RINSED WELL?
Verify the rinse water jets on the
1-
washing arms are not obstructed by
any solid residue.
Verify solenoid valve filter is free from
2-
any obstructions such as lime or scale.
Verify the inlet water pressure is more
3-
than 29psi, if not install an external
pressure device to increase
inlet water pressure inside the
machine.
THE DISHES ARE NOT DRIED WELL ?
1- Ask the rinse aid supplier to verify the
instructions for the rinse aid dosing.
(see par. 2D)
2- Verify if the rinse aid container is
empty. If yes, fill it with rinse aid
product. (see par. 2D)
3- Verify the quality and the quantity of
the rinse aid used and check with the
supplier. (see par. 2D)
4

– TROUBLESHOOTING

DOES NOT 4- Verify the rinsing temperature is
1- Verify if the rinse aid container is
supply is
2- Verify the quality and the quantity of
3- Remove the glass rack immediately
1- Use only non foaming products for
1- Verify washing water temperature is
2- Ask the supplier to verify the instruction
3- Ensure the tank has not been cleaned
4- If foaming detergent has been used,
SMEARS OR SPOTS ON THE GLASSES ?
1- Ask
the
IN
EXTINGUISHER MUST BE USED.
IN CASE OF DANGER CUT-OFF THE
ELECTRICAL SUPPLY IMMEDIATELY.
The Manufacturer reserves the right to
modify
this publication without prior notice.
between 80°C (176°F) to 90°C (194°F)
degrees.
CONDENSATION ON GLASSES ?
empty. If yes, fill it with rinse aid
product. (see par. 2D)
the rinse aid used and check with the
supplier. (see par. 2D)
after the end of each cycle.
STAINS ON GLASSES ?
professional dishwashers.
EXCESSIVE FOAM IN THE TANK ?
not less than 50°C (122°F) degrees.
for the rinse aid dosing.(see par. 2D)
with an unsuitable cleaner. Drain the
tank and rinse throughly before a new
wash cycle.
drain and refill the tank with water
until the foam disappears.
the supplier to
instruction for the rinse aid dosing.
EMERGENCY
CASE OF FIRE A
the data presented
verify the
POWDER
in
15