MVP EV18 Instructions Pour L'installation, Emploi Et Entretien page 8

2
- INSTRUCTION FOR INSTALLER / MAINTENANCE
ATTENTION
Qualified technicians
machine are obliged to train the operators
the machine
about utilization
safety procedures to be followed. They
must provide a real "demonstration" and
verify that machine's instructions are
available to the operators.
Following warnings should be noted:
The dishwasher must
in accordance with local
the absence of local
in accordance with
requirements in the
Code, NFPA 70, Canadian Electrical Code
(CEC), Part 1, CSA C22.1, and Standard for
Ventilation Control and Fire Protection of
Commercial Cooking Operations, NFPA 96.
WARNING!
DO NOT OPEN THE DOOR QUICKLY IF
CYCLE HAS NOT ENDED.
DO NOT DIP BARE HANDS INTO THE
WASHING SOLUTION.
DO NOT REMOVE THE
MACHINE HAS NOT BEEN DISCONNECTED
FROM THE POWER AND WATER SUPPLY.
DO NOT BYPASS
PROTECTION DEVICES (MICROSWITCHES,
PANELS, ETC)
PROVIDED
MACHINE MANUFACTURER IF NOT IN THE
PRESENCE OF TRAINED TECHNICIAN THAT
CAN TAKE THE PROPER PRECAUTIONS.
DO NOT UTILISE THE MACHINE TO WASH
OBJECTS OF SHAPE, TYPE, SIZE, AND
MATERIAL NOT COMPATIBLE WITH THE
MACHINE.
DO NOT OPERATE THE MACHINE IF NOT
PROPERLY CONNECTED, ACCORDING TO
THE SPECIFICATIONS AND REQUIREMENTS
OF THE LOCAL LAW AND PRESCRIPTION OF
MANUFACTURER, MAKING SURE THAT ALL
SAFETY DEVICES ARE OPERATIVE.
ID/RATING/DATA PLATE
ID/Rating plate of the appliance contains
identification and technical data and is
located on front panel.
installing the
and
be installed
codes, or in
codes, installed
the applicable
National Electrical
PANELS IF THE
THE MACHINE'S
BY THE
-
2A – WATER CONNECTION
N.B.
The shut-off valve must be a single
direction, spool, sphere, lid control type,
which can shut off the water supply
quickly and totally. The water pressure
and flow must conform to the data
diagram supplied with each machine.
1- Position the dishwasher and level the
appliance by turning the respective
height-adjustable feet. (Fig.4)
Fig. 4
2- Connect the solenoid valve, which feeds the
machine, to the water shutoff valve,
using a flexible line.
machine must have its own water
supply line.
Fig. 5
2A1 – WATER SUPPLY PRESSURE Check
that the dynamic water supply pressure,
measured between the appliance and the
mains, is between 29 and 58 psi. If the
pressure is too high, install a suitable
pressure reducer on the inlet pipe. If the
pressure is low, install an additional external
pressure pump. (par.1D – Technical Data)
In case of new install or long term appliance
inactivity, drain the water line to eliminate air
bubbles and foreign bodies present in new or
unused water lines. Failure to do so could
damage the machine.
2A2 – WATER HARDNESS
If water hardness is higher than acceptable,
install a water softener of adequate size
before the feed solenoid valve. (par.1D –
Technical Data)
If there is a high concentration of
mineral residue in the water or high
conductivity, we recommend installing the
demineralization filter for 5/7° f.
(Fig.5) Each
7