[801] Rfjamdetect; [802] Wirelesssupervision Window; [810] Wirelessoption; [841] Motion Cameras - Tyco DSC PowerSeries Neo HSM2HOST Guide D'installation

5.
Once all options are configured, the system returns to the base configuration menu.
6.
Repeat the process described above to configure other wireless devices.
[804][801] RF Jam Detect
To configure RF jamming:
1.
Enter Installer Programming section [804][801] then select one of the following options:
00–Disabled
l
01–UL20/20-USA
l
02–EN30/60-Europe
l
03–Class630/60-British
l
2.
Press [*] to accept the selection.
3.
Press [#] to exit the section.
[804][802] Wireless Supervision Window
For EN installations, 1 hour or 2 hours must be selected.
When option 06 is used, which configures the system to generate fault conditions after a device has
been detected as absent for 24 hours, smoke detectors generate a fault condition after a maximum of
18 hours when the 200s supervision toggle option is disabled.
To program the Wireless Supervisory Window:
1.
Enter Installer Programming section [804][802].
2.
Select one of the following options by scrolling or entering the hotkey:
00–Disabled
l
01–After 1Hour
l
02–After 2Hour
l
03–After 4Hour
l
04–After 8Hours
l
05–After 12Hours
l
06–After 24Hours
l
3.
Press [*] to accept the selection.
4.
Press [#] to exit the section.
Note:
For UL Residential Burglary (UL1023), Home Health Care (UL1637), ULC Residential Burg-
lary (ULC/ORD-C1023) installations, the maximum Supervision window shall be set to 24 hours.
For UL Residential Fire (UL985) installations, the maximum supervision window is set to 200s.
For UL Commercial Burglary (UL1610/UL365) and ULC Residential Fire (ULC-S545), the maximum
supervision window shall be set to 4 hours.
[804][810] Wireless Option 1
To program wireless options:
1.
Enter Installer Programming section [804][810].
2.
Select one of the following options by scrolling or entering the hotkey:
01–RF Delinquency
l
02–WirelessSupervisory/RF Jam Alarm
l
03–WirelessTamper
l
04–Fire Supervision
l
3.
Press [*] to accept the selection and [#] to exit.

[804][841] Motion Cameras

To program motion cameras:
1.
Enter Installer Programming section [804][841].
2.
Select one of the following options by scrolling or entering the hotkey:
- 9 -