Specificationsand Features; Compatible Wirelessdevices - Tyco DSC PowerSeries Neo HSM2HOST Guide D'installation

Specifications and Features
Current Draw: 60mA
l
Voltage: Draws current from the PowerSeries Neo alarm controller (10.8VDC to 12.5VDC) -
l
(Limited Power Supply)
Frequency: 433MHz (HSM2HOST4), 868MHz (HSM2HOST8), 912-919MHz
l
(HSM2HOST9
Zones - can receive signals from up to 128 wireless zones, plus 16 wireless keypads. Also sup-
l
ports up to 32 wireless keys or 32 panic pendants and 16 sirens
Supervisory - programmable supervisory window
l
Can be wired up to 1000 ft. / 230 m from the main panel with 22 AWG wire
l
Connects to Corbus
l
Compatibility: The HSM2HOST is used with PowerSeries Neo alarm panels
l
Operating temperature: 0°C to +49°C (32-122°F)
l
Relative humidity: 93% non-condensing
l
Separate, built-in wall and case tampers
l
Note:
For Commercial BURG (UL) the Supervisory window shall be set to 4 hours.
For ResidentialFire (UL/ULC) the Supervisorywindowshallbe setto200seconds.
For ResidentialBURG(UL/ULC) the supervisorywindowshallbe setto24hours.
For ULHome Healthcare applicationsthe supervisorywindowshallbe setto24hours
Onlymodelsoperatinginthe band912-919MHz are UL/ULC listedwhere indicated.OnlyULapproved
devicesare tobe usedwithUL/ULC listedsystems.
Compatible Wireless Devices
The HSM2HOSTx (x= 4/8/9) can receive signals from the devices listed in the following chart. Please
refer to the instruction sheet of the device for operating instructions. Throughout this document, x in the
model number represents the operating frequency of the device as follows: 9 (912-919 MHz), 8
(868MHz), 4 (433MHz).
UL
)
- 3 -