Grohe 36 407 Notice D'utilisation page 107

Thermal disinfection

Runtime of thermal disinfection
>
4 min
d/s d  d/s d
23 min
d
Set value.
Z
Factory setting: 4 min
^d Zd ^dKW
Start/stop thermal disinfection
^ E
Turn the mixer lever or thermostat to the hot water stop.
The command is transferred to the fitting immediately.
Point remote control at the sensor system.
Start thermal disinfection.
The status indicator shows whether the data transfer was
successful. The fitting starts thermal disinfection.
Stop thermal disinfection before the end of the runtime in
the setting.
The status indicator shows whether the data transfer was
successful. The fitting stops thermal disinfection.
Content
106