Makita ML120 Manuel page 6

ML180
Voltage
18 V
Storing battery cartridge
Always charge the Nickel Metal Hydride battery car-
tridge before storing it when you do not use it for more
than six months.
Head angle (Fig. 3)
The head angle can be adjusted in four stages. Adjust
as desired.
Replacing bulb (Fig. 4 & 5)
CAUTION:
The bulb is very hot immediately after operation. Wait
until the bulb cools off before attempting to replace it.
First, turn the ring counterclockwise and remove the
reflector. Then replace the bulb.
6
Battery cartridge
1822
1833
1834
1835
Operating time
Approx. 190 min.
Approx. 220 min.
Approx. 260 min.
Approx. 300 min.
Shoulder strap (Fig. 6)
Install the strap on the tool.
MAINTENANCE
To maintain product safety and reliability, repairs,
maintenance or adjustment should be carried out by a
Makita Authorized Service Center.
ACCESSORIES
CAUTION:
These accessories or attachments are recommended
for use with your Makita tool specified in this manual.
The use of any other accessories or attachments
might present a risk of injury to persons. The acces-
sories or attachments should be used only in the
proper and intended manner.
• Bulb set (2 pcs)
• Shoulder strap
• Set plate (For Model ML120)
Charger
DC1801