PEDROLLO E1 Mono Mode D'emploi Original page 58

Configuring MODE 2
SELECT
MODE CONFIG
9
MODE CONFIG
MODE:1
6 9
9
MODE CONFIG
SETUP
MODE2 CONFIG
9
MODE2 CONFIG
MODE2 CONFIG
LOGIC:ALTERN.
Configuring MODE 3
SELECT
MODE CONFIG
9
MODE CONFIG
MODE:1
6 9
9
MODE CONFIG
SETUP
9
MODE3 CONFIG
MODE3 CONFIG
MODE3 CONFIG
LOGIC:ALTERN.
58 | ENGLISH
• Press the
• Press the
• Press the
MODE:2
(from modes 1 to 6)
• Press the
• Press the
• Press the
• Enable (ON) or disable (OFF) input IN1
IN1:ON
• This input is used to start a single electric pump according to the alternating
logic
• Enable (ON) or disable (OFF) input IN2
IN2:ON
• This input is used to start the second electric pump according to the alter-
nating logic, or to start both electric pumps simultaneously
• If the system has two electric pumps, enable (ALTERN.) or disable (SIN-
GLE) the alternating logic.
• Press the
• Press the
• Press the
MODE:3
(from modes 1 to 6)
• Press the
• Press the
• Press the
• Enable (ON) or disable (OFF) input IN1
IN1:ON
• This input is used to start a single electric pump according to the alternating
logic
• Enable (ON) or disable (OFF) input IN2
IN2:ON
• This input is used to start the second electric pump according to the alter-
nating logic, or to start both electric pumps simultaneously
• If the system has two electric pumps, enable (ALTERN.) or disable (SIN-
GLE) the alternating logic.
key to confirm the choice and enter the submenu.
key to enter the submenu and change mode.
or key to select mode 2
key to confirm the choice of MODE:2
key to continue with the configuration
key to enter the mode 2 configuration submenu
key to confirm the choice and enter the submenu.
key to enter the submenu and change mode.
or key to select mode 3
key to confirm the choice of MODE:3
key to continue with the configuration
key to enter the mode 3 configuration submenu