Ecom Instruments MCAL 4200 Manuel D'instructions page 65

Figure 13. Connections for Outputting Thermocouples
4.9 Sourcing Ohms / RTDs
To source an RTD, follow these steps:
1. Select lower display from the Main Menu, and choose [RTD] from the primary parameters.
2. Choose output [OUT] from the input/output control, and select RTD type from the sensor
types.
3. Connect the calibrator to the instrument being tested, as in Figure 14.
4. Enter the temperature or resistance using the keypad.
Figure 14. Connections for Outputting RTDs
64