RK Rose+Krieger EP Serie Notice D'assemblage page 39

7. Working life
7.2.3 Installation with fixings
In all installation work, you must adhere to the specified tor-
horizontal installation
ques for the screws used. Note the tempering for the screws
and separate information for accessories supplied. Only com-
pliant conditions will guarantee the safety and long working
life of the linear shaft. Take the values from the table in these
instructions.
Sliding block fixings
This linear unit can be fixed by bolting the end elements to a
vertical installation
suitable base.
7.2.4 Installing the optional accessories
Mechanical limit switch
The technical specifications for limit switches can be found in the catalogue. Ensure that the ca-
bling is safely laid out during installation. Avoid damage to the cabling, for example by having ra-
dii that are too small, as this can lead to failure of the system. The cabling must not be in the path
travelled by the linear unit.
Limit switches are installed by means of a rail, which is secured to the end elements of the linear
unit with support elements. Limit switches can be moved axially and fixed to the rail..
39