Axis Communications P3365-V Guide D'installation page 12

I/O Connector
Use with external devices in combination with, for example, tampering alarms, motion detection,
event triggering, time lapse recording and alarm notifications. In addition to the 0 V DC reference
point and power (DC output), the I/O connector provides the interface to:
• Digital output – For connecting external devices such as relays and LEDs. Connected
devices can be activated by the VAPIX® Application Programming Interface, output
buttons on the Live View page or by an Action Rule. The output will show as active
(shown under System Options > Ports & Devices) if the alarm device is activated.
Digital input – An alarm input for connecting devices that can toggle between an open
•
and closed circuit, for example: PIRs, door/window contacts, glass break detectors,
etc. When a signal is received the state changes and the input becomes active (shown
under System Options > Ports & Devices).
Audio Connector
The Axis product has the following audio connectors:
Audio in (pink) – 3.5 mm input for a mono microphone, or a line-in mono signal (left
•
channel is used from a stereo signal).
Audio out (green) – 3.5 mm output for audio (line level) that can be connected to
•
a public address (PA) system or an active speaker with a built-in amplifier. A stereo
connector must be used for audio out.
SD Card Slot
An SD card (not included) can be used for local recording with removable storage. For more
information, see Specifications, on page 13.
NOTICE NOTICE NOTICE
To prevent corruption of recordings, the SD card should be unmounted before removal. To
unmount, go to Setup > System Options > Storage > SD Card and click Unmount.
Control Button
The control button is used for:
Resetting the product to factory default settings. See page 17.
•
• Connecting to an AXIS Video Hosting System service or AXIS Internet Dynamic DNS
Service. For more information about these services, see the User Manual.
AXIS P3365–V Fixed Dome Network Camera
12