Axis Communications P3365-V Guide D'installation page 17

AXIS P3365–V Fixed Dome Network Camera
Complete the Installation
1.
Side lid
2. Dome cover
1. If the cables are routed along the wall, remove the side lid from the camera's dome cover.
2. Rotate the black shield inside the dome to match the camera's position.
3. Clean the dome with a dry soft cloth to remove dust and finger prints and use a blower
to remove dust from the lens.
4. Make sure the gasket sits securely on the dome cover, mount the dome cover and tighten
the screws using the supplied screw driver. Now that the dome is in place, check that
the camera is properly focused.
The installation is now complete.
Access the Product
Use the tools provided on the Installation and Management Software CD to assign an IP address,
set the password and access the video stream. This information is also available from the support
pages on www.axis.com/techsup/
Reset to Factory Default Settings
Important
Reset to factory default should be used with caution. A reset to factory default will reset
all settings, including the IP address, to the factory default values.
1
17