Networking The Pdu - Tripp-Lite PDUMH15AT Manuel De L'utilisateur

2. Installation
2.2.7 Selecting Input Voltage Range (optional: Models PDUMH15HVAT,
PDUMH15HVATNET, PDUMH20HVAT and PDUMNH20HVATNET only):
These models have two selectable nominal input voltage ranges: 200V-208V ("LO") and
220V-240V ("HI"). Press the button next to the display to toggle the nominal voltage setting to the
desired "HI" or "LO" range. This setting adjusts the voltage ranges for the primary and secondary
inputs. The display will indicate "HI" or "LO" for five seconds.
2.2.8 Connect Equipment to PDU:
Do not exceed the load rating of the PDU. The total electrical current used by the PDU will be
displayed on the digital meter in amperes. Each outlet includes a green LED that illuminates when
the outlet is receiving AC power.
2.2.8

2.3 Networking the PDU

2.3.1 Preparation
MAC Address: The 12-digit MAC address (000667xxxxxx) label is located below the RJ45 jack on
the unit's front panel.
Determine Installation Method: If your network's DHCP server will assign a dynamic IP address to
the device automatically, proceed to Dynamic IP Address Assignment. If you will assign a static IP
address to the device manually, proceed to Static IP Address Assignment. If you are uncertain
which method to use, contact your network administrator for assistance before continuing the
installation process.
2.3.2 Dynamic IP Address Assignment
Connect to Your Network: Connect a standard Ethernet
patch cable to the RJ45 Ethernet port on the unit
Note: This port does not support PoE (Power over Ethernet)
applications.
The device will attempt to obtain an IP address via DHCP .
This may take as long as several minutes, depending on your
network environment.
Discover IP Address: Contact your network administrator to determine which IP address has been
assigned to the device by the DHCP server. The device can be identified on the DHCP server by
referring to its MAC address (see Step 1-3). You may wish to request a long-term lease period for
the IP address, depending on your application. After you have discovered the IP address, proceed
to 2.4 Test and Configure.
Note: The DHCP address is also displayed during boot-up when connected to a computer through the
configuration cable and a terminal emulation program.
16-05-185-9335E0.indb 6
PDUMH20AT
PDUMH15AT
PDUMH20ATNET PDUMH20HVAT, PDUMH20HVATNET
PDUMH15ATNET
PDUMH15HVAT, PDUMH15HVATNET
.
A
On PDUMH20HVATNET,
connection is on the reverse side.
6
Secondary Input
9
A
7/28/2016 3:04:43 PM
Primary Input