Aligning The Sct 410 With The Longitudinal Center Plane Of The Vehicle; Aligning The Sct 410 By Spirit Level - Bosch SCT 410 Notice Originale

en 14 | SCT 410 | Operation
4.2 Aligning the SCT 410 with the longi-
tudinal center plane of the vehicle
i
Manufacturer-specific specifications are required for
correctly aligning the SCT 410. They are described in
the corresponding "Multi Target Shop short instruc-
tions".
1. Find the manufacturer-specific values for aligning
the SCT 410 in the "Multi Target Shop short instruc-
tions".
2. Place the SCT 410 in front of the vehicle.
3. Attach the P-Assist S5 to laser mount A.
1
Fig. 6: P-Assist S5 in laser mount A
1 P-Assist S5
4. Switch on the P-Assist S5.
 The laser line now runs across the vehicle.
5. Align the SCT 410 in such a way that the manufactu-
rer badge (Fig. 7, item 2) on the front of the vehicle
and the antenna (Fig. 7, item 3) are highlighted by
the laser line (Fig. 7, item 1).
 The SCT 410 is now aligned with the front of the
vehicle.
3
1
Fig. 7: Centering the SCT 410 in front of the vehicle
1 Laser line
2 Manufacturer badge
3 Antenna
|
1 690 386 066 2017-08-11
1
2
1
i
If the manufacturer badge and the antenna are not
located along the longitudinal center plane of the
vehicle, the manufacturer badge on the tailgate can
be used as a second reference point. If so, open the
tailgate and highlight the center of the manufacturer
badge on the vehicle front and the tailgate with the
laser line.

4.3

Aligning the SCT 410 by spirit level

¶
Use the star knob screws (Fig. 8, item 3) to align the
SCT 410 by way of the spirit levels on the precision
measuring bar (Fig. 8, item 1 and item 2).
1
3
Fig. 8: Aligning the SCT 410
1 Spirit level for roll angle
2 Spirit level for pitch angle
3 Star knob screws on the base plate
2
3
3
Robert Bosch GmbH