Nemaxx P6 Mode D'emploi page 36

The general troubles, the possible reasons and the solutions are as following.
After solving problems start the stove again:
Problem
1. The start light or display does not
light when power is on
2. The blower doesn't work after
pressing the start bottom.
If after stabilization, it doesn't work,
there must be something wrong
EN
Reason
No power in stove or in the
control panel.
Fuse is broken
It is normal.
It will start automatically
when the temperature is
above 30 degrees on the
venting pipe.
No power in stove or in the
control panel.
Or unplugged on the mother
board
The low temperature sensor
is broken
36
Solution
Check the power and wires.
Replace the fuse
Please wait
Check the power and wires.
Plug in
Replace it
Version: 10
25.10.2021