Nemaxx P6 Mode D'emploi page 33

CLEANING THE CONVECTION BLOWER
To clean the convention blower, disconnect the stove power cord from the electrical outlet.
Remove the side panels and rear panel (For all models) (and front bottom cover for NB-PI, NB-PS,
NB-P01, NB-PE09 ).
A vacuum can be used to remove any dust accumulation on the blower's blades or inside the blower duct.
Be careful to not damage the blower's blades during cleaning.
CLEANING THE VENT PIPE
Soot and Fly ash: Formation and Need for Removal
The products of combustion will contain small particles of fly ash that will collect in the exhaust
venting system and restrict the flow of the flue gases. Incomplete combustion, such as occurs during
start up, shutdown, or incorrect operation of the room heater will lead to some soot formation which
will collect in the exhaust venting system.
The exhaust venting system should be inspected at least once every year to determine if cleaning
is necessary. Sweep the pipe as needed. A tee and the cleanout in the vent system attached to the
stove's flue collar will facilitate this cleaning.
Required Cleaning Schedule after Number of Bags Burned
Burn Pot = 10 bags
Ash Drawer = 50 bags
Flue Fan = 100 bags
Blower = 100 bags
NOTE:
Cleaning schedule will vary depending on quality of pellets used. Burned high ash
pellets used. Burned high ash pellets will require more frequent cleaning.
EN
33
Version: 10
25.10.2021