Michelin MCP 1100 Notice D'utilisation page 11

Press the ON / OFF switch (3)
To switch off intermittent operation mode:
Release the ON / OFF switch (3)
Switching continuous operation on:
Press and hold the ON / OFF switch (3) down and press the locking button (a).
To switch off continuous operation mode:
Press and then release the ON / OFF switch (3).
3.3. Speed Control (F)
Use the speed control to set the desired working speed.
Press the "+" button to increase the speed.
Press the "-" button to decrease the speed.
Refer to the display for the set speed.
Set speed = Display x 100
3.4. Using a polishing machine
When using waxing and polishing agents, observe the instructions issued by
their manufacturer!
The Velcro fastener enables easy changing of the polishing attachment.
3.4.1. Use the foamed plastic attachment to apply the polishing agent.
3.4.2. Make sure that the foamed plastic attachment is free of any foreign
bodies.
3.4.3. Spread the polishing paste evenly over the polishing pad. Do not apply
the polish directly to the polishing surface.
3.4.4. Switch the polishing machine on and off only when the polishing
machine is resting on the polishing surface.
3.4.5. Place the extension lead over your shoulder and work first on the
large,flat surfaces such as the bonnet, boot lid and roof.
3.4.6. Keep your movements as regular as possible.
3.4.7. Work next on the smaller surfaces (doors, for example)
3.4.8. Use the fleece (8) attachment to finish off the polishing (G).
3.4.9. Make sure that the fleece (8) attachment is free of all foreign bodies.
3.4.10. Remove the layer of polish in the same order as it was applied.
Important! Allow the polishing machine to glide over the polishing
surface. Do not exert pressure!
11