Publicité
Les langues disponibles
Les langues disponibles
5.2 | Connecting up
The ProCharger Comfort Indicator is intended to be permanently connected to the ve-
hicle battery. In order to connect the Comfort Indicator correctly, follow the instructions
below:
1. First disconnect the motorcycle earth connection from the battery, then disconnect
the positive terminal
2. Screw the red ring terminal (positive) of the ring terminal cable to the battery's positi
ve terminal.
3. Then, screw the black ring terminal (negative) of the ring terminal cable and the mo-
torcycle's earth connection to the battery's negative terminal.
Carry out the above steps with care. It is imperative that you avoid short-circuits and
make sure the contact is secure.
6 | Using the Comfort Indicator
The ProCharger Comfort Indicator is simply connected permanently to the battery by me-
ans of the ring terminals. Whenever you want to check your battery's charge level, you only
need to briefly press the button on the ProCharger Comfort Indicator, and the charge level
is displayed for 60 seconds via the three differently coloured LEDs.
• Green: (> 12,5 V) indicates a fully charged battery
• Yellow: (12,35 V-12,5 V) means it is advisable to charge your battery
• Red:
(< 12,35 V) means your battery is virtually flat and must be charged
The battery then does not self-discharge.
If the red or yellow LED indicates the need to charge your battery, simply connect your
ProCharger to the Comfort Indicator and start charging. When charging the battery, please
also follow the information provided in the instructions for use of the particular ProCharger
and/or your battery.
18
7 | Transportation and storage
When transporting the ProCharger Comfort Indicator, it is best to use the original packa-
ging to provide optimal protection.
After removing the Procharger Comfort Indicator from its packaging, install it on your
motorcycle in a position where it is protected against rain and strong vibration. If you
do not intend to install it immediately, store it indoors to keep it safe from wind and we-
ather. The temperature should be between +1°C and +55°C with a max. humidity of 99%
(non-condensing).
8 | Maintenance
NOTICE!
Danger of short-circuit!
Never immerse the Comfort Indicator in water or any other liquid.
Use a dampened soft cloth for surface cleaning. Do not use aggressive cleaning agents,
brushes with metal or nylon bristles, or sharp or metallic cleaning objects such as kni-
ves, hard spatulas or similar. These can damage the surfaces.
19
Publicité
Chapitres
