Haier HB18FGSAAA Manuel page 31

GB
10.1 Unpacking
WARNING!
The appliance is heavy. Always handle with at least two persons.
Keep all packaging materials out of children´s reach and dispose them in an environ-
mentally friendly manner.
Take the appliance out of the packaging.
Remove all packaging materials.
10.2 Environmental conditions
the temperature inside the appliance and its energy consumption. Do not install the appli-
ance near other heat-emitting appliances (ovens, refrigerators) without isolation.
10.3 Space requirement
Required space when door is opened (Fig. 10.3):
Width
in mm
W1 W2 D1
600
830 1424 D3
1034
10.4 Ventilaton cross-section
safety reasons, the information of the required venti-
lation cross sections must be observed (Fig. 10.4).
This refrigerating appliance is not intended to be used
as a built-in appliance.
10.5 Aligning the appliance
The appliance should be placed on a at and solid sur-
face.
1. Tilt the appliance slightly backwards (Fig. 10.5).
2. Set the feet to the desired level.
3. The stability can be checked by alternately bump-
ing on the diagonals. The slightly swaying should
be the same in both directions. Otherwise the
frame can warp; possible leaking door seals are
the result. A low tendency to the rear facilitates
the closing of the door.
Depth Distance to wall
in mm
D2
885
D4
1130
10- Installation
in mm
D5
50
1.
max 45°
D5
D1 D3
W1
D2
D4
W2
>10 cm
>10 cm
2.
3.
10.3
10.4
10.5
31