Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Operation
Installation on a counter:
The appliance can be handled by a single person. For ease of use, it is recommended that the appliance is
placed on a table or work surface so as to have the control panel in front of you (recommended height: 90 cm,
to be adapted as required for the user).
Installation when built into the countertop:
Before cutting out the countertop, check the following points in order to be sure that the appliance will be
perfectly usable once built-in:
Make sure there is sufficient clearance (behind, above, below) for proper installation and operation of the
appliance.
The cut-out in the countertop represents a rectangle measuring 168mm x 198mm:
•
Make sure there is a minimum clearance of 135mm beneath the countertop.
•
The free space above must measure at least 495mm.
•
The minimum clearance to the rear must be 102mm (distance between the cut-out and the wall).
•
The minimum clearance sideways must be 30mm.
Multiple cut-outs:
It is recommended to leave a distance of 100mm between 2 cut-outs.
Adapting the appliance to use it as a built-in version:
•
Disconnect the appliance from the mains.
•
Remove the jar (1) and hood lid (8).
•
Tip the appliance backwards.
•
Using a Torx screwdriver, remove the 3 screws located between the metal casing and motor surround (6).
8
Publicité
Table des Matières
