Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
The appliance stops after the motor has overheated, "OVER TEMP": (the motor unit is hot)
•
Put the On / Off switch (4) to the 0 position and unplug the appliance.
•
Wait for the motor to cool down (20 to 45 minutes) then press the On / Off switch (4) (position 1).
The appliance stops as a result of an overload.
The LCD screen does not light up:
A motor overload can occur if there is an excessive quantity or something too hard in the jar.
Under these circumstances, either the thermal protection or the excess current protection may be activated
and stop the appliance operating. If the appliance is hot, refer to the section "The appliance stops as a result of
motor over-heating").
Otherwise:
•
Turn off the electric power supply (unplug the mains power cord (10)).
•
Move the On / Off switch (4) to the 0 position.
•
Under the appliance (fig. O), press the button (25) to reset the excess current protection. If the button does
not remain in the "reset" position, allow the appliance to cool down before repeating the operation.
The appliance stops further to an overload "OVERLOAD":
A motor overload can occur if there is an excessive quantity or something too hard in the jar.
•
The recipe is not appropriate for the quantity and consistency.
•
Reduce the quantity.
•
Choose a different recipe with slower speeds.
The appliance resets while it is operating:
Eliminate all multiple power sockets and plug the appliance into its own individual power supply.
Noises, vibrations, leaks at jar blade level:
•
Check the blade is correctly tightened (first dismantle the blade bearing).
•
Replace the bearing seals.
See the chapter: "Changing the blade".
If the problem persists, turn the appliance electric power off (unplug the mains power cord (4)) and call on
someone from the maintenance department or contact an approved Omcan dealer.
Problem with the recipes:
A few basic rules make it easier to understand how a blender works and thus know how to adapt the recipe
cycles to the products being processed.
Note: Do not overload the appliance: it is better to run a short recipe twice rather than double the
quantities and cycle time: prolonged operation heats the food due to friction and affects the desired
Troubleshooting
17
Publicité
Table des Matières
