Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Fitting the blade:
Take care to comply with the order given for assembly of the various components:
1. Lipped seal (15) (be sure to install correctly with lip downwards),
2. Thrust washer (14),
3. Blade (11) (recesses upwards),
4. Thrust washer (14) (the lipped seal must be pushed far enough for the square of this washer to work with
the square of the shaft)
5. Fixing nut (13) (tighten the nut by hand, checking that the washer in point 4 is correctly positioned relative
to the square of the shaft.
Tighten the fixing nut.
Assembling the bearing on the jar:
•
Place the bearing seal (16) on the bearing (12).
•
Place the locking ring seal (18) on the locking ring (17).
•
Place the bearing (12) inside the jar (1).
•
Screw down the locking ring, take care that the locking ring seal remains in its seating.
•
Tighten well by hand, or with a lever.
FAULT FINDING
Identifying the cause of appliance stoppage with precision.
In all circumstances, if the problem persists, disconnect the electric power supply (unplug the mains power
cord (10)) and call on someone from the maintenance department or contact an approved Omcan dealer.
13
14
11
12
15
Maintenance
18
17
14
15
16
Troubleshooting
Publicité
Table des Matières
