AL-KO Snow Line 560 II Mode D'emploi page 29

Snow Line 560 II, 620 II, 620E II
230 V Starting procedure (620E II)
1.
Switching off the engine
1. Set the throttle to Slow
In order to prevent freezing, continue running
„
the auger and impeller until they are mostly
free of snow.
2. Turn the engine key to Stop and remove (
x The engine switches off.
3. Turn the fuel tap to the Closed position (
Danger: risk of severe injury!
The engine may coast down. After switching off,
make sure that the engine is at a standstill.
469186_c
2.
( 34).
35).
Operation
Danger - risk of injury!
Wear work clothing and protective gear.
▪ Winter clothing
▪ Non-slip winter shoes
▪ Eye protection (safety glasses or visor)
▪ Hearing protection
Starting operation
1. Prepare the snow blower for operation.
2. Check the position of the snow discharge chute and
adjust the discharge direction using the hand
„
crank (
adjust the discharge height (
„
3. Start the engine.
4. Set the wheel drive speed (
The forward speeds range from 1 to 5, 1 being
„
the slowest speed and 5 the fastest speed.
The reverse speeds are R1 and R2, R1 being
„
the slower speed and R2 the faster speed.
35-1).
5. Press the auger drive clutch lever (
Danger: risk of severe injury!
Keep away from the augers while they are in
motion. Keep other persons or animals away.
6. Press the wheel drive clutch lever (
x The snow blower starts moving.
Stopping operation
1. Release (disengage) the auger and wheel drive
clutch levers (
In order to prevent freezing, continue running
„
the auger and impeller until they are mostly
free of snow.
x The snow blower stops moving and the auger
and impeller stop running.
36-1).
36-2).
36-3):
37).
37).
38-1).
GB
29