AL-KO Snow Line 560 II Mode D'emploi page 28

GB
▪ If the skid plates are worn (sliding edge
( 24-1) worn through, turn 180° and use
the other side (
▪ See the replacement parts list when ordering
replacements.
Checking the tyre pressure
Check the tyre pressure before the first use in winter and
then at least once every three months during the period
of use.
The maximum allowed tyre pressure is indicated on
the tyres ( 20-1). Note: 1 bar = approximately 14.5 psi
Inspecting the machine
Each time before starting, check to make sure that the
four shear pins ( 25-1) are intact.
Replace broken shear pins with original replacement
parts. Using unauthorised replacement parts may cause
severe damage to the machine! See the replacement
parts list when ordering replacements.
Check all controls, safety devices, nuts, screws and bolts
on the machine to make sure that they are firmly secured
and in good condition, and and that no parts are missing.
28
24).
Starting the engine
Danger - risk of poisoning!
Never leave the engine running in an enclosed
space.
Position indicators:
Choke
CLOSE OPEN
Gas
Fast Slow
Engine key
Off On
Fuel tap Closed
Open
Primer button
Starting procedure
1. Check the oil and fuel levels.
2. Open the fuel tap (
3. Set the choke to ON (
4. Press the primer button 3 times at 2-second inter-
28-1). In temperatures under 10 °C, press
vals(
the primer button 5 times.
5. Move the throttle to the Fast position (
6. Insert the engine key (
„ Starting manually:
7. Pull the starter rope lightly until you feel resistance,
then pull out briskly and allow the rope to return
slowly ( 31).
Translation of original user instructions
AL-KO snow blower
27).
27-1).
29).
30-1).