Operation; Remote Control - Renkforce TB230WW Notice D'emploi

9. Operation

a) Remote control
The remote control has a range of up to 8 m. Make sure there are no objects (e.g. furniture) between the
remote control and remote control sensor (5), as those could interfere with the transmission signal.
Avoid using the remote control near other products that generate infrared radiation, as such can
affect the operation of the remote control. At the same time, other remote controls could be
affected by this remote control if used in its near proximity.
First time use
Upon delivery, there is a plastic insulation strip located in front
of the pre-installed type CR2025 button cell battery. Pull this
insulation strip from the battery compartment (22). That will
release the contact and the remote control is ready for use.
Replacing the battery
• Remove the battery when the Soundbar does not receive the
remote control signals properly any more.
• Pull out the battery holder as shown and remove the
exhausted battery. Refer to the marking on the rear side of
the remote control.
• Insert a new type CR2025 button cell battery into the battery
holder. Observe correct polarity (+/-) as shown in the adjacent
picture.
• Push the battery holder back into the battery compartment
until it locks into place.
28
1
1
2
2