Télécharger Imprimer la page

Danby Designer DDMW1125BBS Manuel Du Propriétaire page 7

Publicité

Les langues disponibles

Les langues disponibles

IMPORTANT SAFETY INSTRUCTIONS
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
SAFETY - SUPERHEATED LIQUID
Liquids are able to be overheated beyond the
boiling point without appearing to be boiling
due to the surface tension of the liquid. Visible
bubbling will not always be present when the liquid
is removed from the microwave. This could result
in very hot liquids suddenly boiling over when a
utensil or other item such as a tea bag is inserted
into the liquid.
To reduce the risk of injury:
• Do not overheat liquids. Do not heat any liquid
for more than 2 minutes per cup.
• Stir liquids before and halfway through heating.
• Do not use straight-sided containers with narrow
necks as this can cause a build up of steam.
• Superheated liquid can begin to spontaneously
boil when removed from the microwave.
After heating, allow the liquid to stand in the
microwave for 30 seconds before removing.
• Use extreme care when inserting a utensil or
other item into hot liquids.
The contents of milk bottles and baby food jars
should be stirred or shaken and the temperature
checked before serving in order to avoid burns.
Do not defrost frozen beverages, especially
carbonated beverages, in this microwave as they
could explode.
Hot foods and steam can cause burns. Be careful
when opening any container that has been heated
in the microwave. Direct the opening away from the
hands and face to avoid burns.
SAVE THESE INSTRUCTIONS!
SAFETY - ARCING
Arcing refers to sparks inside the microwave while it
is in operation. Arcing is caused by:
• Metal or foil inside the microwave.
• Recycled paper towels being used inside the
microwave, as these can contain small pieces of
metal.
If arcing is present, stop operation and remove any
metal or paper towels from the microwave.
RADIO INTERFERENCE
This microwave generates and uses ISM frequencies
and if not installed and used properly in strict
accordance with the manufacturer's instructions,
it may cause interference to radio and television
reception. It has been type-tested and found to
comply with limits for ISM Equipment pursuant
to Part 18 of the FCC Rules, which are designed
to provide reasonable protection against such
interference in a residential installation.
However, there is no guarantee that interference
will not occur in particular installations. If this
microwave does cause interference to radio or
television reception, which can be determined by
turning the equipment off and on, the interference
can be corrected by one or more of the following
methods:
• Reorient the receiving antenna of radio or
television.
• Move the microwave away from the receiver.
• Plug the microwave into a different outlet so that
the microwave and receiver are on different
branch circuits.
The manufacturer is not responsible for any
radio or TV interference caused by unauthorized
modifi cation of this microwave. It is the
responsibility of the user to correct such interference.

Publicité

loading