Using The S Blade In The Large Workbowl - Black & Decker Performance FP6000 Guide D'utilisation Et D'entretien

• To slice cooked meat, including salami and pepperoni, food should be
very cold. Cut in pieces to fit feed tube and process food using firm,
even pressure.
• Remove the slicing/shredding disk before removing the workbowl from
the processor.

USING THE S BLADE IN THE LARGE WORKBOWL

1. Lock workbowl in place on base.
2. Carefully insert the blade shaft into the S blade. When
the S blade gets to the bottom of the shaft, turn
clockwise to lock (Q). You will feel it lock into place.
3. Place blade and shaft attachment in work bowl on
center post.
Note: The blade attachments are very sharp. Use caution
when handling and storing.
4. Place food in workbowl.
5. Place lid on workbowl and lock into place by rotating lid
counterclockwise.
6. Make sure food pushers are securely in place in feed chute. Never use
your fingers to direct food through chute.
7. Turn the speed control dial to select your speed.
Press toggle up towards START|OFF to start the food processor.
8. To add food or liquid while processor is running, remove food pusher
and insert through the feed chute. Replace food pusher in chute.
9. When finished, press the toggle up towards START|OFF and allow blades
to stop revolving before removing lid. Twist lid clockwise to remove from
the workbowl.
Note: Press toggle down towards PULSE to chop items such as nuts,
onions, bread crumbs and cracker crumbs. Press and
hold the toggle downward towards PULSE for several
seconds, then release. Repeat until food reaches desired
consistency.
Important: Be sure S blade has completely stopped
spinning and unplug appliance before removing lid from
processor.
10. To unlock workbowl, turn it clockwise and lift off base.
11. Carefully remove S blade by pulling shaft straight up
and empty workbowl.
Note: To remove S Blade from blade shaft, turn counterclockwise and pull blade
shaft out from bottom. (R)
12. Unplug appliance when not in use.
13
Q
R