Using The Dicing Disk - Black & Decker Performance FP6000 Guide D'utilisation Et D'entretien

U SIN G TH E D IC I N G DI SK
Important: The dicing disk can only be used with the large
workbowl. Only run the processor on LOW speed when using
the dicing disk. DO NOT use dicing disk with small workbowl.
1. Lock workbowl onto base.
2. Place the dicing shaft into the bottom of the dicing
disk and turn clockwise to lock it into place. (H)
3. Carefully pick up the dicing assembly using the
finger holes in the top of the disk and place in the
workbowl over the center post. (I)
4. Place the dicing disk with the grid facing the
workbowl handle (facing right) into the workbowl.
Note: Dicing disk can only be properly installed when grid
faces the processor handle.
5. Push the dicing disk down, making sure it is secure
in the work bowl.
6. Grasp dicing blade by the center using the finger
grips. Insert the curved plastic edge under the outer
edge of the dicing disk. (J) Place center of blade
down onto the top of the visible dicing shaft in the
center of the dicing disk. You may need to rotate the
center of the blade slightly to find the fit.
Important: Be sure to only handle blade with the safe
finger grips.
Important: Always place the curved end of the blade
under the lip of the dicing disk FIRST and then place the
center of the blade on the center post of disk.
7. Place the lid on the food processor and lock into place.
Place the ingredients to be diced into the feed chute.
8. Turn the dial to the left (counterclockwise) to a LOW
speed setting. Press the toggle up towards start. Use
the food pusher to guide ingredients down.
Important: Do not use the dicing disk on MEDIUM or
HIGH speed. Only use LOW speed for best results.
9. After dicing and turning the processor off, unplug. Then
remove the lid and carefully lift the blade off the center
post by lifting center of blade first, then pulling the
curved edge up and away from the work bowl lip. (K)
10. Prior to removing the dicing disk from the workbowl, place the dicing cleanout
tool in the holes on the dicing disk, aligning the outer posts with the outer
notches (L). The curved edge of the cleanout tool aligns with the curved edge
(O RANG E)
9
H
I
J
K
L