Télécharger Imprimer la page

tomado TDW5501B Mode D'emploi page 37

Publicité

Les langues disponibles

Les langues disponibles

CLEANING THE DRAIN PUMP
Large food residues or foreign objects which were not captured by the filters may block the waste water pump. The rinsing
water will then be above the filter.
Warning Risk of cuts! When cleaning the waste water pump, ensure that you do not injure yourself on pieces of broken
glass or pointed implements.
• First always disconnect the appliance from the power supply.
• Take out the basket.
• Remove the filters.
• Scoop out the water, use a sponge or cloth if required.
• Check the area and remove any foreign objects.
• Install the filters.
Position the appliance in the desired location. Make sure the location is solid and flat. The dishwasher is equipped with water
supply and drain hoses that can be positioned either to the right or the left sides to facilitate proper installation.
ELECTRICAL CONNECTION
Ensure the voltage and frequency of the power corresponds to those on the rating label. Only insert the plug into an electrical
socket which is earthed properly. Use the required fuse 16 amp.
COLD WATER CONNECTION
Connect the cold water supply hose to a threaded 3/4 (inch) connector and make sure that it is fastened
tightly in place.
If the water pipes are new or have not been used for an extended period of time, let the water run to
make sure that the water is clear. This precaution is needed to avoid the risk of the water inlet to be
blocked and damage the appliance.
Attention: the dishwasher can not be connected to a warm water supply.
DRAIN HOSE CONNECTION
Insert the drain hose into a drain pipe with a minimum diameter of 40 mm, or let it run into the sink, making sure to avoid
bending or crimping it. The top of the hose must be less than 600 mm.
please hang up the drain hose either way A or B
Note: the top of the
hose must be less
than 600 mm.
front
drain pipe
PLACING THE DISHWASHER
A
B
Ø 40 mm
EN - 37
hang de afvoerslang volgens manier A of B
Let op: de bovenkant
van de aansluiting
moet lager zijn
dan 600 mm.
voorkant
afvoerslang
Counter
Aanrecht
A
B
Ø 40 mm

Publicité

loading