tomado TDW5501B Mode D'emploi page 30

USING THE APPLIANCE FOR THE FIRST TIME
Before using the appliance for the first time, you should proceed as follows: carefully unpack the appliance and remove all
packaging material, also from the inside, and any promotional stickers.
Keep the packaging (plastic bags, polystyrene and cardboard) out of the reach of children.
After unpacking the appliance, carefully check it for external damage that may have occurred during transport.
Place the appliance on a sturdy, flat surface. Prior to using the machine for the first time please check whether the electricity
and supply water specifications match the values indicated by the installation instructions for the appliance.
Remove all packaging materials inside the machine.
Fill the salt reservoir and fill up with water until it almost overflows. Set the water hardness setting.
Fill the rinse aid reservoir.
FILLING THE SALT RESERVOIR
For a good washing result, the dishwasher needs soft, i.e. less calcareous water. Otherwise, white lime residues will remain
on the dishes and the interior of the dishwasher. This has a negative effect on your applinace's washing, drying and shining
performance. For this purpose, dishwasher salt is used.
• Remove the basket and unscrew the cap of the
salt reservoir (1).
• Fill with salt till the overflow level, about 1.0 kg
(2).
• Fill the reservoir before first use with water. It
is normal for a little water to flow out of the
opening when doing this.
• Screw the cap back on firmly.
ATTENTION!
• Remove any spilled salt and run a full program to prevent corrosion to the bottom.
• Refill the salt reservoir when the indicator light of the salt reservoir lights up.
SETTING THE SALT CONSUMPTION
To find out the water hardness level in your area, contact your local water company. Adjust the salt consumption according to
the table on the next page.
Note! Hardness level is adjusted to level 4 as a factory setting.
• Close the door and switch on the machine.
• Press and hold the Program button P for 5 seconds to enter the mode for setting the salt consumption. This must be set
within 60 seconds after turning the machine on.
• Set the level by pressing Program button P repeatedly. Use the table of water hardness level settings.
• After adjusting the level of water hardness, press the On/Off button to confirm and store the setting. If the setting is not
confirmed, it is stored automatically after 5 seconds.
Table of water hardness level settings
Water hardnesss German hardness
level °dH
1)
H1 0-5
H2 6-11
H3
12-17
H4 * 18-22
H5 23-34
H6 35-45
1
Open
International indication Program indicator
hardness mmol/l hardness level
2)
0-0.9 ● indicator light RAPID30 on
1.0-2.0 ● indicator light DELICATE on
● indicator light DELICATE on
2.1-3.0
● indicator light RAPID30 on
3.1-4.0 ● indicator light ECO on
● indicator light ECO on
4.1-6.1
● indicator light FAST30 on
● indicator light ECO on
6.2-8.0
● indicator light DELICATE on
EN - 30
2
Regeneration occurs every X
program cycles
3)
none
10
5
3
2
1