tomado TDW5501B Mode D'emploi page 34

SWITCHING THE DISHWASHER ON AND OFF
1 2
• Switch the dishwasher on by pressing the On/off button (1).
• Press the Program button (2) to select the appropriate washing programme, the programme indicator will be lit.
• Press the Start/Pause-knop (3) to start the program. The indicator light of the selected program will blink.
When the machine has finished a buzzer will sound for 8 seconds. The indicator light of the used program stops blinking.
• Switch the dishwasher off with the On/off button (1).
NOTE! You can slightly open the door and wait a few minutes before unloading the dishwasher. The dishes and
cutlery will still be very hot and may break as a result of the heat. Moreover, the dishes dry better when allowed
to stand for a few minutes.
CHANGING OR PAUSING A PROGRAM
A programme can only be changed if it has been running only for a short period of time, otherwise the detergent may have
already been released or the the washing water with detergent has already been drained. If this is the case, the dishwasher
must be reset and the detergent dispenser must be refilled.
If you would like to change a program while a washing cycle is already running.
• Press during 3 seconds the Start/Pause button (3). Select another program and switch the dishwasher on again.
TIP: forgot to add a dish?
1. Press the Start/Pause-button (3) to pause the program.
2. Carefully open the door a little.
3. Wait until the spray arm stops turning and than open the door completely.
4. Place the forgotten dishes in the dishwasher.
5. Close the door.
6. Press the Start/Pause-button (3) to restart the program. The program will resume after 10 seconds.
SETTING THE DISHWASHER
EN - 34
3