Publicité
Les langues disponibles
Les langues disponibles
Fax +1 305 430 9692
Clean all parts of the appliance before the first use (see section:
•
CLEANING).
Make sure the appliance is steady and add the pusher (2) on the
•
carriage (6).
Plug in the appliance in a wall outlet. The slicer is now ready to
•
use.
Place a plate or a dish below the blade, at the back of the
•
appliance, to collect the slices.
Move the carriage away from the blade and lay the food to be
•
sliced on the stainless steel surface of the carriage.
Push the food against the back plate (3) of the appliance with
•
the pusher (2) and select the slicing thickness – up to1/2" - by
turning the adjusting knob (8).
Place the switch (9) to the "ON" position. The blade will start
•
rotating and the pilot light of the switch goes on.
Push the carriage using your thumb on the thumb guard (1) to
•
bring the food towards the blade (4). Therefore, use the handle of
the carriage and keep the pressure on the back plate of the
appliance using the pusher. Do not apply too much pressure, for
best results.
If it becomes difficult to slice the food (important braking of the
•
blade), move back a little bit and start the operation again by
approaching the blade slowly.
To avoid food sticking to the appliance, and to improve the
•
slicing, you can moisten or oil the blade surface with a towel
beforehand.
Do not slice meat with bones, food with large seeds, or food still
•
wrapped (string, wrappers, and aluminum foil).
Do not attempt to slice extremely hard or deep frozen food.
•
Once slicing is done, switch the appliance off and wait until the
•
blade comes to a complete standstill. Place the thickness
adjustment dial in the "P" position.
STORAGE
When not in use, it is recommended that the thickness adjustment
dial gets turned down all the way until the mark "P", so that the
blade's sharp edge is concealed - this in order to avoid any risk of
accidental cuts or injuries.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International USA. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
Print only what is inside the frame.
6
Assembly page 6/32
AS 40763 - 120501
Publicité
