Publicité
Les langues disponibles
Les langues disponibles
Fax +1 305 430 9692
The pusher can be cleaned in warm soapy water. Rinse well after
•
cleaning. Do not put in the dishwasher.
DO NOT IMMERSE THE APPLIANCE IN WATER OR ANY OTHER LIQUID!
•
Dry all parts well before storage.
•
DANGER! BLADE IS VERY SHARP!
•
REMOVING BLADE FOR DEEP CLEANING
Switch off the appliance and unplug it from the power socket.
•
To remove the blade, turn the locking device (5), located in the
•
center on the blade, clockwise to remove the blade by hand (no
tool or coin necessary).
Wash the blade in warm soapy water. Do not wash in the
•
dishwasher! Let it dry thoroughly.
Clean the housing behind the blade with a dry cloth or a soft
•
brush.
To put the blade back in place, proceed inversely and lock the
•
blade by turning the locking device counter-clockwise.
Be very careful during this operation as the blade is very sharp!
•
IMPORTANT INFORMATION
A lubricant paste is applied at the factory in order to ensure
•
correct lubrication for the first couple of usage. After this, the first
time you remove the blade, the user can remove the extra
lubrication paste or leave it. The paste is food safe. No extra
lubrication will be needed afterwards.
Just cautiously cleaning the blade surface after use as indicated
•
in the user manual should avoid cross-contamination. Deep
cleaning by removing the blade shall only be necessary from
time to time .
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International USA. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
Print only what is inside the frame.
8
Assembly page 8/32
AS 40763 - 120501
Publicité
