Publicité
Les langues disponibles
Les langues disponibles
Fax +1 305 430 9692
4. Never use the slicer for more than 10 minutes continuously.
5. The cutting blade continues to rotate after the slicer has been
switched off. Wait until the blades have stopped completely.
6. For reasons of safety, the slice thickness dial must be returned to
the "P" position after use.
7. Be careful with the blade at all times. Blade is very sharp!
POLARIZED PLUG INSTRUCTIONS
This appliance is equipped with a polarized plug (one blade is wider
than the other). To reduce the risk of electric shock, this plug will fit
into the polarized outlet only one way. If the plug does not properly
fit into the outlet at first, reverse it. If it still does not fit, contact a
qualified electrician. Do not attempt to modify the plug in any way.
SHORT CORD INSTRUCTIONS
A short power supply cord is provided to reduce the hazards resulting
from becoming entangled in, or tripping over a longer cord.
Extension cords may be used if care is exercised in their use.
The electrical rating of the extension cord should be at least
•
that of the appliance. If the electrical rating of the extension
cord is too low, it could overheat and burn.
The resulting extended cord should be arranged so that it will
•
not drape over the counter top or tabletop where it can be
pulled on by children or tripped over.
IMPORTANT INFORMATION
This appliance is not for commercial use. You should follow the
requested breaks. Failure to follow this instruction carefully may result
in damage to the motor. Please refer to the rating label for the
maximum continuous usage time (KB xx min where xx is the
maximum usage time). The breaks should last at least 30 minutes.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International USA. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
Print only what is inside the frame.
4
Assembly page 4/32
AS 40763 - 120501
Publicité
