Meec tools 018762 Mode D'emploi page 35

LOADING FASTENERS
1. Press the lock button. Pull back the cover
on the magazine.
FIG. 3
FIG. 4
2. Put a pack of fasteners in the magazine.
FIG. 5
NOTE:
The pointed end of nail fasteners should rest
against the bottom edge of the magazine
when loading.
The tops of the staples should rest against
the top edge of the magazine.
3. Push the magazine cover forward to
spring out the lock button.
WARNING!
• The product must be connected to the
power supply to start firing. Always
disconnect the product from the power
supply before loading fasteners, to avoid
firing fasteners unintentionally. Check
that the magazine is empty before
connecting the product to the power
supply, otherwise there is a risk of
serious personal injury.
• Only use fasteners recommended by the
manufacturer. The use of other fasteners
can result in a risk of personal injury
and/or material damage.
• Never point the outlet at yourself or
anyone else when loading fasteners –
risk of serious personal injury.
• Check that the trigger or interlock
mechanism are not activated when
loading fasteners – risk of serious
personal injury.
REMOVING FASTENERS FROM
MAGAZINE
1. Remove the battery.
2. Press the lock button. Pull back the cover
on the magazine.
3. Remove all fasteners from the magazine.
4. Push the magazine cover forward to
spring out the lock button.
WARNING!
• Always remove all the fasteners from
the magazine before putting the product
away.
• Disconnect the product from the power
supply before removing fasteners from
the magazine.
ADJUST THE DRIVING DEPTH
The driving depth for fasteners can be adjusted.
Adjust the driving depth with the knob on the
tip of the product.
FIG. 6
1. Turn the adjuster knob to the left (B) to
increase the driving depth.
2. Turn the adjuster knob to the right (A) to
reduce the driving depth.
IMPORTANT:
Check the driving depth on a spare piece of
wood.
ADJUSTING THE FIRING METHOD
FIG. 7
1. Move the selector for the firing method
to the left for single firing. In this position
the trigger must be pressed each time
to drive in a fastener. The safety element
must be pressed and then the trigger
must be pressed to fire a fastener.
2. Move the selector for the firing method to
the right for contact firing. In this position
EN
35