Optional Accessory - DeWalt DCS690 Guide D'utilisation

English
Installing Abrasive and Diamond Wheels
(Fig. A, D)

WARNING: Install only one blade.
1. Lay unit on a firm surface, with the arbor screw
facing upward.
2. Using supplied 1/2" (13 mm) open end wrench
(located in the battery compartment), remove arbor
screw 11 , outer clamp washer
if one is installed. Hold arbor screw
with spindle lock button
right hand.
3. The inner clamp washer 22
double D shaft and retaining ring.
4. Slip wheel over spindle
24
Start threading on arbor screw which will self align outer
clamp washer.
iMPORTAnT: Make sure the diamond blade is installed
with the correct rotation, as marked on the blade
rotation indicator 12 .
5. Engage spindle lock button and tighten screw firmly
with wrench. Do not over-tighten arbor screw.
6. Turn wheel by hand to ensure it is properly centered.
The wheel should not hit the shoe or guard. The screw
and flanges should be tight.

CAUTION: Only use 9" (230 mm) Type 1/41 wheels
with 7/8" (22.2 mm) arbor hole with this tool. Never
force a wheel onto the machine or alter the size of the
arbor hole.
Fig. D
24
Replacing Worn Clamp Washers (Fig. D)

WARNING: Replace clamp washers as they wear.
They may become sharp with extended use.
1. Remove the arbor screw
and used wheel 21 if one is installed as described in
Installing Abrasive and Diamond Wheels.
2. To remove the inner clamp washer
retaining ring that holds the inner clamp washer to the
double D shaft.
10
11
6
20 and used wheel 21
11 from turning
13 . Spindle threads are
is held in place with a
. Slip on outer clamp washer.
11
20
21
22
12
11 , outer clamp washer 20
22 , first remove the
3. Remove the inner clamp washer and replace with a new
one. Orient the inner clamp washer with the depressed
center section toward the blade. Make sure the new
inner clamp washer is secure with the retaining ring
in place.
4. Install the wheel , new outer clamp washer
21
arbor screw 11 as described in Installing Abrasive and
Diamond Wheels.
Adjusting the Guard Angle (Fig. E)

WARNING: Do not use guard rotation handle to
hold tool while cutting. Guard rotation handle is
only used for adjustment of the guard while tool is
not in use.

CAUTION: Guard may be hot. Use guard handle to
rotate guard.

WARNING: Always make sure the guard is properly
engaged before starting the machine.
You can adjust the angle of the guard.
1. To adjust the angle of the guard, pull back the guard
rotation release lever 14
2. Grasp the guard 2 firmly by guard rotation handle
and rotate to desired angle.
3. Release the guard rotation release lever and make sure
it engages, locking the guard in place. If the guard
rotation release lever doesn't engage, rotate the guard
slightly until the guard rotation release lever returns to
the locked position.
Fig. E
2
D WALT Tool Tag Ready (Fig. F)
e

Optional Accessory

Your cut-off saw comes with mounting holes
fasteners for installing a D WALT Tool Tag. You will need
e
a T15 bit tip to install the tag. The D
designed for tracking and locating professional power
tools, equipment, and machines using the D
Connect™ app. For proper installation of the D
Tag refer to the D WALT Tool Tag manual.
e
, and
20
and hold it.
10
10
14
15 and
WALT Tool Tag is
e
WALT Tool
e
WALT Tool
e