Electrical Connection - S&P COR-PRO V W Mode D'emploi

During removing component process, take extreme precautions to avoid falling objects that could damage the
curtain or injure the manipulator.
EN
Following sketch below, prepare the installation site to anchor the air curtain to the ground. This must be
fi nished and must not be under construction yet. Mark the anchor points and make the holes where the plugs
and anchors will be placed. Check the absolute horizontality of the base. Pass all the electrical connection
cables through the hole designed for this purpose and install the pipes for the water coil.
Plan lengths of electrical cables to reach the connection points located in the upper part of the curtain.
Use only appropiate anchors, plugs and dowels. Carefully analyze the installation location and suitability of
the anchors and fasteners used, as well as the strength of the structure. Always consider the capacity of the
fl oor. The manufacturer is not responsible for failured caused by improper use of plugs, fasteners and/or
suspension material.
It is recommended to use electrical wire gutter or similar to guide securely electrical cables in their vertical
route to the upper terminal box.
Once the air curtain is installed, check the vertically and correct is necessary.

8. ELECTRICAL CONNECTION

Air curtain must be protected by its corresponding
electrical protections depending on the electrical pa-
rameters of each model (see wiring diagram and/or
nameplate). Connect cables to the terminals following
mentioned wiring diagram, check connections, equipo-
tential bonding and, fi nally, turn the power supply on.
Use cables with adequate section for load requested.
Make sure that cables are not twisted or deformed. As shown in the image above, it is recommended to use an electrical
wire gutter so that the electrical cables can run vertically through the air curtain in a safe way. Leave ends of individual
cables free long enough for easy handling. Cut wires to a length that will allow them to reach the top of the unit.
To access into connection terminals, you must fi rst remove protective control cover.
22
M10 Nut
M10 Screw
Plastic anchor