Introduction; Safety Regulations And "Ce" Marking; General Instructions And Warning; Reception, Transportation And Storage - S&P COR-PRO V W Mode D'emploi

2. INTRODUCTION

Thank you for purchasing this appliance. It has been manufactured in full compliance with applicable safety regulations
and EU standards. Please read this instruction book carefully, as it contains important information for your safety during
the installation, use and maintenance of this product. Keep it at hand for future reference.
Please check that the appliance is in perfect condition when you unpack it, as all factory defects are covered by the S&P
guarantee. Also, check that the appliance is what you have requested and technical data in nameplate matches your
needs.

3. SAFETY REGULATIONS AND "CE" MARKING

S&P technicians are fi rmly committed to research and development of ever more effi cient products and in compliance
with current safety regulations.
The instructions and recommendations given below refl ect current regulations, principally regarding safety,
and therefore are based on compliance with general regulations. Therefore, we recommend all people expo-
sed to hazards to strictly follow the safety regulations in force in your country.
S&P will not be held liable for any possible harm or damage caused by noncompliance with the safety regulations, as
well as caused by modifying the product. The CE mark and the corresponding declaration of conformity are proof of the
product's conformity with current EU regulations.

4. GENERAL INSTRUCTIONS AND WARNING

A hazard analysis of the product has been carried out as provided in the Machine Directive. This document
contains information for all personnel exposed to these hazards, with aim of preventing possible harm or
damage due to faulty handling or maintenance.
All maintenance operations (ordinary and extraordinary) must be carried out with the machine switched off and the
electrical power supply disconnected.
Before connecting the power supply cable to the terminal strip, make sure the mains voltage corresponds to the voltage
indicated on the specifi cations nameplate of the unit.
COR-PRO V W air curtain has been designed to prevent heat and cold losses and improve fi ltration between
two spaces. Any other use or application will be out of purpose for which air curtain was designed. The
manufacturer will not be responsible of damages resulting from an inappropriate use. Read and follow this
document before start up the air curtain.
Authorized and qualifi ed professionals following local regulations must carry out both the hanging installa-
tion, the electrical connection and any repairs.
The manufacturer reserves the right to make any change without previous notice, due to marketing or production reasons.

5. RECEPTION, TRANSPORTATION AND STORAGE

5.1. RECEPTION

Check carefully delivery note content that is part of your delivery. Check all items listed into the delivery
note with special attention to accessories that could not be part of the main equipment volume or not ins-
talled into the unit. Check that packaging received are complete and in good conditions. Otherwise, inform
the carrier and record it on the delivery note document. Then, immediately inform the transport company
or the manufacturer.

5.2. TRANSPORTATION

Observe the instructions on labels placed on the unit. During transportation the air curtain package must not
be tilted or placed in a different position than recommended by the manufacturer. The packaging incorporate
nameplates with serial number and product description to facilitate identifi cation.
Equipment must be transported in the original packaging only. This packaging has been tested for a long time and other
alternatives may damage the unit. Transport and handling must be done with appropriate capacity equipment.
These transportation equipment must be handled by qualify staff. For a safety handling of the air curtain, at least a mi-
nimum number of two people is required.
EN
19