Kemper MaxiFil Clean Notice D'utilisation page 70

9. Reinsert the mains plug back into the socket and switch the product on.
The green signal lamp indicates fault-free operation of the product.
7.2.3 Changing the cooling air intake filter
Ite Description
m
4 Filter holder
1. Provide a new filter insert (item 5) and a disposal bag.
2. Switch off the product at the device switch.
3. Prevent unintentional restarting by disconnecting the mains plug.
4. Pull the filter insert (item 5) forwards out of the filter holder (item 4)
without stirring up dust particles.
5. Seal the contaminated filter insert (item 5) in a disposal bag and dispose
of it according to the regulations.
6. Push the new filter insert (item 5) into the filter holder (item 4) as far as
it will go.
7. Reinsert the mains plug back into the socket and switch the product on.
The green signal lamp indicates fault-free operation of the product.
1502827-03
Fig. 19: Cooling air intake filter change
Tab. 16: Cooling air intake filter change
- 70 -
Ite Description
m
5 Filter insert
EN