Safety Instructions - IKEA MASTERLIG Mode D'emploi

ENGLISH
If the glass ceramic surface / glass surface is cracked, switch
•
off the appliance and unplug it from the mains. In case the
appliance is connected to the mains directly using junction
box, remove the fuse to disconnect the appliance from
power supply. In either case contact the Authorised Service
Centre.
If the supply cord is damaged, it must be replaced by the
•
manufacturer, the Authorised Service Centre or similarly
qualified persons in order to avoid a hazard.
WARNING: Use only hob guards designed by the
•
manufacturer of the cooking appliance or indicated by the
manufacturer of the appliance in the instructions for use as
suitable or hob guards incorporated in the appliance. The
use of inappropriate guards can cause accidents.

Safety instructions

Installation
Warning! The appliance must be
installed by the authorised
installer.
Follow the Assembly instructions
supplied with the appliance.
• Remove all the packaging.
• Do not install or use a damaged
appliance.
• Keep the minimum distance from other
appliances and units.
• Always take care when moving the
appliance as it is heavy. Always use safety
gloves and enclosed footwear.
• Seal the cut surfaces with a sealant to
prevent moisture from causing swelling.
• Protect the bottom of the appliance from
steam and moisture.
• Do not install the appliance next to a door
or under a window. This prevents hot
cookware from falling from the appliance
when the door or the window is opened.
• Make sure that the space underneath the
hob is sufficient for air circulation.
• The bottom of the appliance can get hot.
If the appliance is installed above the
drawers, make sure to install a non-
combustible separation panel under the
appliances to prevent access to the
bottom.
Electrical Connection
Warning! Risk of fire and electric
shock.
• All electrical connections should be made
by the authorised installer.
• The appliance must be earthed.
• Before carrying out any operation make
sure that the appliance is disconnected
from the power supply.
• Make sure that the parameters on the
rating plate are compatible with the
electrical ratings of the mains power
supply.
• Make sure the appliance is installed
correctly. Loose and incorrect electricity
6