Power Supply - Sangean DT-220 Mode D'emploi

Power Supply

The set can be operated by
- Two 1.5V batteries (IEC 46 or UM-3 or AA sizes)
- DC 3V power adapter (not supplied) to connect to
3V DC jack Connector plug 6 mm dia., negative
pole
inside (center negative) .
Insert two 1.5V batteries into the battery
compartment. Make sure they are right way round.
Note:
If display appears low battery symbol
the battery. Run-down batteries should be removed
from the set right away because of the risk of
leakage.
If the set is not going to be used for a longer period,
batteries should also be removed.
Time Set
The first time after batteries are installed, display
will show 0:00 and second starts to count.
To adjust the time only when radio is off. Press
Time Set button for more than 2 seconds, display
11
time set icon also hour digit will flash. Press
Tuning up/down button
press Time Set button again to set the minute. Press
Time Set button again to finalize time setting. The
clock will start from 0 second.
4
, replace
to set the hour then
9