Jet JTS-10 Mode D'emploi page 6

Fig 12
Attach the saw guard to the raving
knife with 1 carriage bolt, washer and
locknut (Fig 13)
Fig 13
7.4 Rising and tilting of sawblade
Setup adjustments of the sawblade
shall never be performed when the
machine is running.
Use the front crank handle to raise
the sawblade.
Use the left crank handle to tilt the
sawblade.
Start the machine with care.
7.5 Rip fence setup
Attach the rip fence base with the
lock knob (C, Fig 14).
Fig 14
Attach the rip fence profile (A) with 2
carriage bolts and 2 lock knobs (B).
The rip fence profile can be placed
flat and adjusted in length.
The cutting of small work pieces
(width less than 120mm) shall only
be performed with the rip fence
profile placed flat (Fig 15).
Fig 15
Start the machine with care.
7.6 Mitre gauge setup
Mitre gauge setup shall never be
performed when the machine is
running.
Use a gauge to exactly set up for 90°
(Fig 16).
Fig 16
Adjust the mitre gauge profile to be
close to the sawblade.
Start the machine with care.
7.7 Adjusting 45° and 90°stops
The positive stops are adjusted at
the factory.
If out of alignment:
Disconnect saw from the power
source, unplug.
Remove cabinet bottom cover.
Adjust stop-nuts on tilting spindle
until blade stops at 90° and 45°.
Reattach cabinet bottom cover.
8
8. Maintenance and inspection
General notes:
Maintenance, cleaning and repair
work may only be carried out after
the machine is protected against
accidental starting by pulling the
mains plug.
Repair and maintenance work on the
electrical system may only be carried
out by a qualified electrician.
Consult a qualified repair shop if a
malfunction or damage occurs to this
tool, including sawblades and
guards.
Cleaning:
Clean the machine regularly.
Inspect the proper function of the
dust extraction daily.
Keep the inside of the cabinet clear
of sawdust and wood chips. Make
sure the motor fan and fan cover are
also kept clear of sawdust.
All protective and safety devices
must be re-attached immediately
after completed cleaning, repair and
maintenance work.
Defective safety devices must be
replaced immediately.
Saw blades:
The servicing of saw blades should
only be performed by a trained
person.
Defective safety devices must be
replaced immediately.
Check saw blades regularly for
faults. Replace a defective
sawblades immediately.
Motor brushes:
The collector brushes are due to
wear and may need replacement by
a qualified electrician only.
Disconnect the machine form the
power source, pull mains plug.
-Remove the cabinet bottom cover.
-Remove the brush covers.
-Replace the collector brushes
(Jet Article Number: JTS10-059
2 pieces needed).
-reattach brush covers and cabinet
cover.
9. Trouble shooting
Motor doesn't start
*No electricity-
check mains and fuse.