Function; Initial Operation - Gardena 1188 Mode D'emploi

Information regarding use :
The Soil Moisture Sensor is equipped with a
safety switch. If the sensor cable is damaged or
the batteries flat, the selected watering time of
the Water Computer will be used for watering.

3. Function

Control panel of
Soil Moisture Sensor :
5
2 4

4. Initial Operation

Insert batteries :
Select correct location for
Soil Moisture Sensor :
With the GARDENA Soil Moisture Sensor the soil moisture level
is taken into consideration for watering.
The Soil Moisture Sensor measures the soil moisture at the root
level of the plants automatically approximately every 10 minutes
and sends the measured results to the Water Computer.
1
Indicator
button :
1
2
"Dry" LED
3
"Damp" LED :
4
Switching
controller :
5
Battery LED :
3
If the batteries are flat and are not replaced, the connected
Water Computer will function with the watering program
selected.
v Replace batteries (see 7. Maintenance "Replace batteries" ).
v To insert batteries (see 7. Maintenance "Replace batteries" ).
Correct location :
The Soil Moisture Sensor must be positioned at a location
in the watering area which is exposed to the same climatic
conditions as the plants (sun, wind, rain, etc.).
Incorrect location :
The Soil Moisture Sensor should not be covered by
neighbouring plants. Areas of shade should be avoided.
To rule out erroneous reaction results caused by waterlogging,
the Soil Moisture Sensor should not be positioned in dips in the
ground.
The spread of moisture in the soil after
watering or rainfall is rather slow.
In the worst-case scenario it may happen that
irrigation and a rain shower overlap until the
required soil moisture is attained.
Activates display of moisture level last
measured.
Indicates that the Soil Moisture Sensor is
measuring dry in relation to the switching
4
controller .
Indicates that the Soil Moisture Sensor is
measuring damp in relation to the switching
4
controller .
Sets the soil moisture level at which
watering is to take place.
If the battery LED flashes the batteries
have to be replaced.
11