EMAK DR55H6,5 Utilisation Et Entretien page 92

Chapter 5: Use
Section 1
Before starting any work activity,
check that there is enough fuel in the
tank (10). Use a funnel with a net filter
when topping up fuel, to prevent any
impurities from entering the tank.
STOP :
Never top up the vehicle with fuel
while the engine is going.
Successively, check the oil level of
the engine using the appropriate bar
(11) positioned at the rear end of the
engine. When working on slopes,
make sure the oil is at the maximum
level in order to warrant a correct and
optimal lubrification.
When topping up oil, only use ESSO
UNIFARM 15-40 W oil. For further
information, please
instruction booklet of the engine.
STOP :
Do not mix different kinds of oil, or
oils with different densities. Use only
and exclusively the oil the builder of
the engine suggests.
Before starting the flail mower make
sure you:
- Check for your safety that the
machine groundspeed and blade
rotor engagement levers are in the
vertical position (Fig. 5.1)
Start/stop engine
consult the
1 2
18
Fig. 5.1
8 9 10
Fig. 5.2