Publicité
Les langues disponibles
Les langues disponibles
™
Max-Flo II
Series __________
Pump Mounting (cont'd)
swimming pool filtration system operate under pressure. Incorrectly installed and/or improperly tested
filtration equipment and/or components may fail resulting in injury and/or property damage.
Plumbing
Use Teflon tape to seal threaded connections on molded plastic components. All plastic fittings must be new or thoroughly
cleaned before use. NOTE - Do NOT use Plumber's Pipe Dope as it may cause cracking of the plastic components.
When applying Teflon tape to plastic threads, wrap the entire threaded portion of the male fitting with one to two layers of
tape. Wind the tape clockwise as you face the open end of the fitting, beginning at the end of the fitting. The pump suction
and outlet ports have molded-in thread stops. Do NOT attempt to force hose connector fitting past this stop. It is only
necessary to tighten fittings enough to prevent leakage. Tighten fitting by hand and then use a tool to engage fitting an
additional 1 ½ turns. Use care when using Teflon tape as friction is reduced considerably; do NOT over-tighten fitting or
you may cause damage. If leaks occur, remove connector, clean off old Teflon tape, re-wrap with one to two additional
layers of Teflon tape, and re-install connector.
Fittings
Fittings restrict flow. For better efficiency, use the fewest possible fittings (but at least two suction outlets). Avoid fittings
that could cause an air trap. Pool and spa fittings MUST conform to the International Association of Plumbing and
Mechanical Officials (IAPMO) standards. Use a non-entrapping suction fitting in pool (multiple drains) or double suction
(skimmer and main drain).
Electrical
regulations, and the National Electric Code (NEC). Ground and bond motor before connecting to
electrical power supply. Failure to ground and bond pump motor can cause serious or fatal electrical
shock hazard. Do NOT ground to a gas supply line. To avoid dangerous or fatal electrical shock, turn
OFF power to motor before working on electrical connections. Fire Hazard - match supply voltage
to motor nameplate voltage. Insure that the electrical supply available agrees with the motor's
voltage, phase, and cycle, and that the wire size is adequate for the HP (kW) rating and distance from
the power source. Use copper conductors only.
www.haywardcanada.com
_____
WARNING –
Hazardous Pressure. Pumps, filters, and other equipment/ components of a
WARNING –
All electrical wiring MUST be in conformance with all applicable local codes,
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
______________________
Page 5 of 8
Publicité
