Monitor Audio Gold W15 Manuel Utilisateur page 9

Set Up
Once in position and cables have been routed (no longer than
10 metres to avoid interference), connect them to the Gold
W15. Mains power cable should be connected last. Do not play
any music at this stage.
NOTE: The entire set up procedure can be done via the control
panel or remote control handset.
NOTE: The Gold W15 automatically switches between inputs.
There is no option to do this manually. The LFE input will take
priority over the Stereo input. The display will show either
LFE or StE as part of the power cycle (see below).
NOTE: There are 3 memory locations for user settings for each
input. Please refer to page 10.
FactorySettings
The default settings are:
LPF: 60hz (stereo input only)
Slope Angle: -24dB/ Octave (stereo input only)
Phase: 0 degrees
EQ: Off
LEO: Off
Volume: -20dB (Note: this is a low setting and should be set to
0dB before configoring).
These should be treated as the initial setting when setting up
your product. Further fine tuning of the settings can be done if
you feel these factory settings do not match your environment
or tastes.
PowerCycle
The Gold W15 can be powered up using either the encoder, the
remote, or fully automatically. It will go through the following
sequence:
Press Encoder/ press Power button on remote/ receive signal
> display shows ON for 2 seconds > the input for 5 seconds,
eg LFE > then the selected preset for 3 seconds, eg 1 > Then
the default operating screen is displayed . (single dot in the
centre of the display).
If no signal is received for 10 minutes, it will go back into
standby mode. If the power button on the remote is pressed it
will enter standby mode. In both cases the display will show
OFF for 10 seconds and then display nothing.
Initial Settings Using an AV Processor/
Receiver
Connect a single interconnect cable (no longer than 10 metres)
from an AV processor/ receiver to the connection marked LFE
input. If you have an additional subwoofer, the LFE Out can be
used to supply the signal.
Using the LFE input, negates the Gold W15's crossover filter.
This needs to be set on the AV processor/ receiver. Please refer
to the product user manual for further information. As a guide,
the crossover should be set up in accordance with the low
frequency limit of the main speakers (see table on page 9).
Before running the auto setup on the AV processor/ receiver
(refer to the AV equipment's owners manual), carry out the
following initial steps:
• Run the LEO room equaliser (Page 8)
• Set the volume to 0dB (Page 4/ 5)
• Phase to 0 (Page 9)
• EQ to OFF (Page 9)
• LEO to ON (Page 10). Leo turns on automatically after
calibration
When the above settings have been made, you can run the
auto set up of the AV amplifier. Further personalisation and
adjustment can be made after the auto set up has been run by
adjusting the EQ. It is also suggested that the settings of the
auto set up are checked against our recommended settings
depending on the rest of your system. Do not be afraid to
adjust them on your AV equipment.
monitoraudio.com 7