Programming With The Easy Controller - Gewiss Easy Manuel D'installation Et D'emploi

Initialization with the Easy Base Unit
1. Power up the device through the bus.
2. Have the system acquire the device with one of the following procedures:
• Automatic acquisition (the device still has the factory settings):
- select the "Application ¡ New function" or "Application ¡ Edit function" menu
in the Easy base unit: the device will be recognized automatically.
• Manual acquisition (the factory settings have been modified):
- select the "Application ¡ Search device" menu in the Easy base unit;
- briefly press (< 2 seconds) the programming key. The programming LED will light
up during the acquisition process (figure A).
The device acquired by the Easy base unit will be listed, with the number assigned, in
the channels of the "Application ¡ New function" or "Application ¡ Edit function" menus.
Initialization with the Easy Controller
1. Power up the device through the bus.
2. Have the system acquire the device with one of the following procedures:
• Automatic acquisition:
- select the "Search/Config." or "Scan Range" command in the "System" menu;
• Manual acquisition:
- select the "Add device" menu in the "System" menu;
- briefly press (< 2 seconds) the programming key. The programming LED will light
up during the acquisition process (figure A).
The device acquired is listed with a number allocated, product code and a list of the
channels in the "Devices" view.
Insert the devices into a Chorus support, making sure the two local command buttons
are on the left.
Complete the installation with other Chorus devices or hole covers and fix it to the relative
container (flush-mounted box, wall-mounted box etc). Apply the finish plate.
INSTALLATION
Completing installation
20