Gewiss Easy Manuel D'installation Et D'emploi page 21

PROGRAMMING WITH THE EASY CONTROLLER
Programming the actuator through the Easy base unit (code GW 90 831) or with Easy
Controller (GW90837 / GW90838 / GW90840).
The device can be selected by proceeding as follows:
• by pressing one of local command buttons: the corresponding channel will be
highlighted in the channel list;
• directly from the list of channels.
The functions can be created after the device has been selected.
Names of the functions
blinds pushbutton
blinds
Shutter edges
scene
priority control
Wind sensor
Rain sensor
Refer to the Easy base unit or Easy Controller documentation for further information on
the programming procedures.
Handling of shutters or blinds using blinds pushbutton
Handling of shutters or blinds using blinds
Handling command for shutters or blinds with edges
Actuation and memorising of the scenes
Override actuation
Actuation with wind alarm
Actuation with rain alarm
21
E
N
G
L
I
S
H