Programming With Easy Controller - Gewiss GW 90 851 Mode D'emploi

The cover guarantees that the power cables and the bus cables are separated by at
least 4 mm (figure F).
4. Connect the load to the special screw terminals above and below the actuator,
checking that they do not exceed the current limits indicated in the Technical
Specifications.
Initialization with the Easy Controller
1. Power up the device through the bus.
2. Have the system acquire the device with one of the following procedures:
• Automatic acquisition:
- select the "Search/Config." or "Scan Range" command in the "System" menu;
• Manual acquisition:
- select the "Add device" menu in the "System" menu;
- briefly press (< 2 seconds) the programming key. The programming LED will light
up during the acquisition process (figure A).
The device acquired is listed with a number allocated, product code and a list of the
channels in the "Devices" view.
Initialization with the Easy Base Unit (GW 90 831)
1. Power up the device through the bus.
2. Have the system acquire the device with one of the following procedures:
• Automatic acquisition (the device still has the factory settings):
- select the "Application ¡ New function" or "Application ¡ Edit function" menu
in the Easy base unit: the device will be recognized automatically.
• Manual acquisition (the factory settings have been modified):
- select the "Application ¡ Search device" menu in the Easy base unit;
- briefly press (< 2 seconds) the programming key. The programming LED will light
up during the acquisition process (figure A).
The device acquired by the Easy base unit will be listed, with the number assigned, in
the channels of the "Application ¡ New function" or "Application ¡ Edit function"
menus.
INSTALLATION
20