When The Following Messages Appear - JVC DLA-RS6710 Instructions

When the following messages appear...

Message
No Input
.
HDMI-1
.
Lamp replacement
Back
.
Description
No device is connected to the input
0
terminal
The input terminal is connected but
0
there is no signal
A video signal that cannot be used with
this unit has been input (The names of
input terminals such as "HDMI-1" and
"HDMI-2" will be displayed in yellow).
This message is displayed when the
accumulated lamp time has exceeded
2900 hours.
To clear the message, press the [BACK]
BACK
button on the operation panel of the
projector unit or the remote control.
Action
Input the video signals.
Input video signals that can be used.
(p. 77)
Get ready a new lamp unit and replace
as soon as possible. Reset the lamp time
after replacing the lamp. (p. 61, 63)
69