Filling The Tank; Dry Ironing - Reliable SENZA 200DS Guide D'utilisation

LABEL IRONING INSTRUCTIONS

FILLING THE TANK

Always check the level of water in the tank while you are ironing.
Add enough water to the tank so that the water level is always visible. Do not go
past the MAX level. If the tank remains without water, you will notice a vibration
and loud noise. Turn off the appliance by pressing the switches (S) and (U) and
unplug it from the electrical outlet.
WARNING: Always turn off the appliance and remove the power cable plug from the
outlet before filling the tank with water.
Add water directly in the tank (Fig. 7). Insert the plug into the electrical outlet and
turn on the appliance again.
If the appliance is not switched off promptly, overheating of the pump could cause
a momentary stoppage of the appliance. Therefore it is necessary to switch off the
appliance and fill the tank. Wait for the appliance to cool down to resume normal
operation.
SPRAY BUTTON
Make sure there is water in the tank of the iron (M). Press the spray button (I). To
enable this feature you may need to press the spray button repeatedly (Fig. 15).

DRY IRONING

To iron dry - i.e. without steam - all you have to do is turn the iron on by pressing
the switch (U) after connecting it to the power supply. Place the steam control
knob to the minimum and adjust the temperature control knob (L) to the desired
temperature. Do not press the steam button.
09
KIND OF FABRIC
Synthetic fabrics:
Acetate
Acrylic
Viscose
Polyamide (Nylon)
Viscose (Rayon)
Silk
Wool
Cotton
Linen
The mark on the label means do not iron
THERMOSTAT
•
• •
• • •